Operating sequence
1. Check the filters 9. At the end of the washing
Ensure they are clean and properly positioned programme
(see "Maintenance and cleaning").
At the end of the programme the
dishwasher will automatically stop.
The "Mains On" indicator light remains on
2. Check that there is rinse aid until the On/Off push button is depressed.
and salt
10. Switch off the dishwasher
3. Load the dishes Switch off the dishwasher by pressing the
Remo ve any scraps of food.On/Off push button and open the door.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc.in it.
When the washing programme has
Slide the baskets back into the machine.finished,it is recommended that the
dishwasher is unplugged and the water
tap turned off.
4. Ensure that the spray arms can
In general it is not advisable to open the
rotate freely.door while the machine is working;if the
door is opened however,a safety device
ensures that the machine stops.
5. Measure out detergent
Add the detergent into the dispenser.Consult
the instructions on the packet.
Important!
Close the detergent dispenser lid.Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished,as
6. Close the dishwasher doorsteam may escape.
7. Set the programme
Turn the programme selector dial clockwise until
the number of the programme you wish to select
corresponds with the programme marker on the
control panel.
8. Start the programme
Depress the On/Off push button.
The "Mains On" indicator light will come on
and the machine will start.
If you wish to interrupt the washing
programme at any time press this button
again.
13SEQ17en |
ACEC
